Structural Repair
- Joist, beam, and rim replacement
- Ledger board reinforcement and re-flashing
- Connection hardware upgrades
- Support post and deck footing reconstruction
Sacramento County · SB 721 & SB 326 specialists
Antelope is not a city: it is an unincorporated community, so building permits, rental inspections, and code enforcement here all come from Sacramento County. Most of its apartment and townhome buildings went up after the late 1980s, when Antelope became a planned community, and many of their balconies and stairs are now reaching their first full round of major repairs. We provide balcony inspection and deck inspection under SB 721 for rental properties and under SB 326 for condo associations, along Antelope Road, Elverta Road, Walerga Road, Don Julio Boulevard, and the rest of the community, When the report finds damage, the deck repair is done by the same licensed team.
Inspection, compliance, repair, and reconstruction for Antelope apartment owners, HOA boards, and property managers — handled end‑to‑end by one licensed team.
What type of property do you manage?
Which exterior structures are 6 feet or more above ground?
Select all that apply
Get your free compliance assessment
We'll send your personalized report within 24 hours
Thank you! We'll contact you within 24 hours with your personalized compliance report.
A large part of Antelope's apartment and townhome stock consists of two-story, wood-framed buildings from the late 1980s, 1990s, and 2000s, with second-floor balconies, exterior stairs, and walkways. At thirty-plus years, the original walking surfaces, sealants, and flashing on the oldest of them have worn out or are close to it, while the framing below has often been repaired in places over the years. Our inspection looks at both: the condition of the surface and the condition and hardware of any earlier repairs underneath.
In Antelope, concrete patios on the ground floor sit at grade, so the state balcony laws do not reach them. On some second-floor balconies and walkways, the walking surface is a cementitious coating over plywood, which looks and feels like concrete underfoot. Since wood framing carries them, they count as covered elements. We sound the coating for hollow, delaminated areas and take moisture readings through cracks, because water trapped under a cementitious surface goes straight into the plywood.
When older wood decks are updated, composite boards are sometimes laid directly over the existing wood decking instead of replacing it. The overlay traps water against the old boards, hides any water damage in them, and raises the walking surface, which lowers the effective height of the guardrail. We check whether composite was installed over old decking, inspect what is underneath, and measure the guard height from the new surface.
A 30-minute on-site walkthrough tells you exactly what's required.
Antelope started as a small railroad settlement; in 1880 the whole of Center Township had about 400 residents. On April 28, 1973, a rail car loaded with aircraft bombs exploded in the Southern Pacific Roseville Yard and damaged most of the homes in town. Large-scale development came later: Antelope became a planned community in the late 1980s, with single-family homes and apartments, its boundaries were set by a vote in 1993, and the Antelope town designation took effect on July 1, 1994. In 2020, the community had 48,733 residents and 15,202 housing units, of which 31.5% were rented.
Because Antelope is unincorporated, rental properties here fall under Sacramento County's Rental Housing Inspection Program, which counts about 90,000 rental units across the county. The County's exterior inspection checklist covers stairways and balconies directly: it calls for stairs free from dry rot and loose steps, balusters no more than 4 inches apart, and balconies free from dry rot and failing beams and supports. Buildings less than five years old are exempt from the inspection part of the program. The state's SB 721 program runs on its own six-year cycle, so many Antelope owners now face two sets of inspections on the same balconies and stairs.
Antelope has the same Central Valley weather as Sacramento: the nearby Sacramento State station records about 19 inches of rain a year and July highs averaging about 94°F, and the region sees around two weeks of 100°F days in a typical summer. Most of the rain arrives between late fall and spring, followed by a long dry season. On buildings that are thirty years old, the long dry season is when coatings and sealant joints crack, and the first winter storms find those cracks.
Issues that repeat across the local building stock — from climate, construction era, or common materials in this area.
Loose stair treads, dry rot in stringers and landings, balusters spaced more than 4 inches apart, and weakened balcony beams all appear on the County's rental inspection checklist. An owner can be cited for them during a County visit even when the SB 721 inspection is years away. We flag these items in our report and fix them, so the same conditions are not found twice.
Since 2004, pressure-treated lumber for residential use has been made with copper-based preservatives that corrode standard steel hardware faster than the older preservatives did. Repairs made since then with ordinary hangers, nails, or screws can corrode at the connection, sometimes within a few years. We check hardware on repaired framing and specify heavier hot-dip galvanized or stainless steel connectors where they are needed.
Wood that stays damp for years softens and loses strength. Sawdust-like debris under a balcony, or a soft spot at a soffit or a stair stringer, usually means water damage behind the finish. We open the area, find where the water comes from, and include the framing repair in the scope.
Porch lights, walkway lights, and electrical conduit are often mounted through balcony soffits or walkway framing. Each penetration is a possible water path, and failed seals around fixtures are a common source of hidden leaks. Each penetration in the sample is checked, and the report marks which ones need new seals or flashing.
On complexes from the late 1980s and 1990s, many balcony and walkway surfaces have been recoated several times or never at all. At this age, owners need to decide whether another coating will hold or the surface must be removed down to the plywood. We test adhesion and check the plywood underneath at sample locations, so the decision rests on what is actually below the surface.
Any Antelope rental property of three units or more needs an SB 721 inspection every six years on top of the County's rental inspections. We work with apartment communities along Antelope Road, Elverta Road, and Walerga Road and with smaller buildings across the community, and our report flags the items the County inspector is likely to look at.
SB 326 applies to Antelope condo associations and requires a nine-year inspection cycle. Only a licensed structural engineer or architect may perform it, using a random sample of the balconies, decks, and stairs in the association's care. We read the CC&Rs first to settle which ones those are.
Antelope townhome and condo HOA boards receive findings by building and a clear choice for each walking surface: recoat or replace, with prices for both. Permits go through Sacramento County, and the board receives the closing compliance letter to share with its insurer and lender.
Fourplexes, townhome communities, senior housing, and small apartment buildings across Antelope, up to the Placer County line.
Serving all of Antelope with fast response times. Most assessments within 3 business days.
After the work is complete, you walk away with a full archive package — ready for your HOA board, insurer, city, or next property sale.
Before, during, and after photos tagged to every structural element inspected.
Full permit package, inspection card sign-offs, and city correspondence archived.
Manufacturer warranties plus our labor guarantee in writing.
Detailed scope-of-work summary covering every repair and reinforcement.
Engineer-signed SB 721 / SB 326 letter for your HOA archive, insurance, and lender.
For Antelope rental properties, the package also lists the corrected items that match the County's rental inspection checklist for stairways and balconies, ready to hand to the inspector on the next County visit. Sacramento County permit records are included in place of city records.
We walk the property, identify scope, and flag any urgent safety items. No cost, no obligation.
Full proposal with line-item pricing, material specs, and a realistic timeline.
We handle city permits and coordinate tenant notices with property management.
One licensed crew, start to finish. Daily photo updates and clean worksites.
City sign-off, warranty package, and compliance letter delivered to you.
Our County rental inspection was coming up, and we were worried about the stairs. ABD found loose treads and balusters spaced too wide on two buildings, fixed them, and gave us a list to show the inspector. The visit went without a single stair citation.
Our walkways had been recoated three times. ABD cut test areas, found the plywood under one building soft, and showed the board why recoating that building again would be wasted money.
Sacramento County. Because Antelope is an unincorporated community, building permits, inspections during the work, and code enforcement are handled by the County rather than by a city government. We prepare the County permit application, schedule the County inspections, and close out the permit when the work is finished.
The County's exterior checklist asks for stairways free from dry rot, deterioration, and loose steps or walkways, with balusters no more than 4 inches apart, and for balconies built to code and free from dry rot and failing beams or load-bearing supports. These checks are part of the County's rental program. Passing them still leaves the owner's SB 721 obligation in place, since that state inspection has its own report.
It depends on what is under the surface. If the existing coating is well bonded and the plywood is dry and solid, a new coating system can be applied. If the coating has lost adhesion or the plywood is wet or soft, recoating only hides the problem, and the surface needs to be removed and rebuilt. We test both at sample locations and give the board or owner a priced repair proposal for each building.
In the wrong city? Jump to the right page for your property.
Tell us about your property and we'll come out, walk it, and give you a written plan — free of charge, no obligation.